How to install the air compressor without oil leakage?

When it comes to air compressor equipment, we know that grease plays an important role. Without grease as a support, our air compressor cannot work normally. However, many people encounter oil leakage when using air compressor equipment. What is the reason?

How to install an air compressor without oil leakage?

1. Proper installation of gaskets: The gaskets between air compressor parts have anti-cracking and sealing functions. If the raw materials, manufacturing quality and installation do not meet the technical specifications, oil leakage will occur.

2. Tighten the nut properly: Too loose will cause the pressure to be too loose and leak, too tight will cause the metal around the thread hole to bulge, or tighten the screw to cause oil leakage.

3. Replace common faulty seals immediately: Due to improper installation and use, seals in many places on the air compressor will throw oil due to the difference between the motor shaft and the edge of the seal. Some seals lose their elasticity due to plastic aging after long-term use.

4. Replace damaged parts immediately: Air compressor parts are damaged beyond the limit after use, causing high-pressure gas in the engine combustion chamber to enter the crankcase ventilation, causing the vehicle oil to leak.

5. Avoid blockage of throttle valve and ventilation valve: If the throttle valve and ventilation valve are blocked, the temperature inside the aluminum panel will rise, gas will fill all the indoor space, increase the pressure inside the aluminum panel, increase the movement resistance of the piston rod, and increase fuel consumption. At the same time, due to the effect of the standard pressure difference inside and outside the aluminum panel, it is often weak and oil leaks.

6. Ensure the sealing of various high-pressure hoses: Since the connecting nuts used in engineering machinery are often disassembled and assembled, they are very easy to loosen due to the breakage of the sliding buckle. If the bell mouth precision of the two connectors is poor, the axes of the two spheres do not coincide or the brightness is different, oil leakage will occur. The sealing of the sphere can be repaired by grinding to make the nut clamped reliably.